Does your cricket bat grip move up the handle? Do you find yourself trying to adjust a grip during an innings? Fed up with sorting out your grip before you bat?

Would you like to have a grip that is secure on the bat handle, allows no movement, no twisting during a shot, and is totally reliable and secure?

GripGrip tape is simple and easy to apply, in just a couple of minutes and at minimal cost, GripGrip stops the grip moving whilst improving the feel of the bat handle.

GripGrip Pro is supplied in a roll and is sufficient for Seven Applications

An end to constant re-gripping and grip replacement
No more concerns about the grip moving up during an innings
The grip no longer moves during a shot, generating confidence
Whilst providing a permanent feel, the grip can be easily changed
GripGrip - the simple economical solution, to a universal cricket problem.

What is GripGrip? It's a highly flexible and stretchy rubber tape that when applied properly to a cricket bat handle, will stop the grip moving. GripGrip has no adhesive, it simply binds to itself, making it easy to remove leaving no sticky residue. GripGrip is not however a cure all, in some circumstances it might fail to hold the grip. Perhaps your binding is unstable or dirty or the grip might be old.

Application Instructions

Start off with your bat grip rolled down the handle.
Making sure your hands are clean, roll your grip towards you by 3" (7.6cm). Check that the binding is in good condition, if the twine is loose, GripGrip will not work.
Remove approximately 4" (10.2cm) of tape and cut with scissors.
Peel off the backing
Pin the GripGrip with your thumb approximately 1" up the binding. Now pull firmly making the GripGrip stretch and go thin.
Wind the tape around the handle, laying it on top of the first layer, overlapping until it covers approximately 2" (5cm) up the handle.
Securing the final part of the GripGrip, apply pressure on top of the already applied GripGrip. Hold for 30s allowing for it to bind to itself.
Now simply roll the grip down handle to it's normal position and GripGrip is applied! Allow 10 minutes for the GripGrip to set before use.

Note: In some playing conditions such as extreme heat or players fitting multiple grips, apply another band of GripGrip further up the handle. Some batsmen prefer GripGrip applied to the top and bottom of the handle, this provides an extra secure grip.

GripGrip - the simple economical solution, to a universal cricket problem.

You may even spot one of our bats in the demo below from ex-England Cricketer, Mark Butcher

GripGrip

GripGrip

GripGrip Pro Roll

Subscribe to our newsletter